Skip to content
Man MadeThings

How to Trim a Beard at Home: Neckline, Cheek Line and Fade

How to trim a beard at home using advice from Philips, Braun and the American Academy of Dermatology: guard lengths, trimming direction, the neckline, cheek line, mustache, fade and beard care.

RVRahul VithalaEditor-in-ChiefPublished · 5 min read

We may earn a commission when you buy through links on this page. Learn more

Man with a neatly trimmed short beard and clean neckline
Image: Braun

Quick answer

Wash and dry your beard, comb it out, then trim against the direction of growth starting with the longest guard and working shorter. For the neckline, place a finger just above your Adam's apple and trim everything below it, curving up to below your earlobes. Tidy the cheek line and mustache, then moisturize with beard oil or conditioner.

A good beard looks effortless, but it isn't. The difference between "distinguished" and "forgot to shave" usually comes down to two lines, the neckline and the cheek line, plus a consistent length.

The good news is you don't need a barber for that. With a decent trimmer and ten minutes, you can keep a beard looking sharp at home.

Below are the steps Philips and Braun, two of the biggest trimmer makers, recommend on their own sites, with skin advice from the American Academy of Dermatology. Need a trimmer first? See our best beard trimmers guide.

Step 1: Wash, dry and comb

Philips beard trimmer
Image: Philips

Start with a clean, dry beard. Philips's instructions begin: wash and dry your beard and face.

Then comb it out. Braun says running a comb against the grain is a great way to untangle knots and spot uneven growth. Philips suggests brushing your beard downward before you trim to avoid stray hairs.

One note from the American Academy of Dermatology: if your skin gets irritated, it suggests applying a shaving oil, cream or gel before trimming and using an electric trimmer. So if you have sensitive skin, a light layer of oil can help, as long as your trimmer is suitable for it.

Check your trimmer, too. Philips explains that the numbers on its combs show the length of hair left after trimming, which makes it easy to repeat the same length every time.

Step 2: Trim to length, against the grain

Beard trimming: start with the longest guard, move against the direction of growth, then step down to your preferred length
Image: Man Made Things

Always start longer than you think. Philips recommends starting with the maximum length setting, especially the first time, and reducing it until you find your preferred length. You can always take more off; you can't put it back.

Move the trimmer against the direction of hair growth. Philips says this removes excess bulk, and Braun says the same: trim all over using your trimmer and guard against the grain. Philips notes that not all hairs grow the same way, so you may need to go over areas in a few directions, especially on the neck and under the chin.

Work in sections: one cheek, then the other, then the chin. Check symmetry often in the mirror. Braun's tip for mustaches applies to the whole beard: use slow, careful strokes and alternate sides to keep it even.

When everything is one length, it's time to shape the lines.

Step 3: Define the neckline

Finding your beard neckline: place a finger just above your Adam's apple; trim below it and curve up to below your earlobes
Image: Man Made Things

The neckline makes the biggest difference to how polished a beard looks. Philips says a neckline matters once a beard grows beyond about 3mm.

Philips's method:

  1. Look straight in the mirror, head upright. Any hair you can see below your chin from this angle should go.
  2. Tilt your head back and place a finger just at the top of your Adam's apple. That's the natural dividing line between beard and neck.
  3. Trim everything below that line, working outward under your jawline to each side.
  4. Define the corners by trimming a line below your earlobes to connect with the line under your chin.

Philips warns not to make the neckline too round; a slight upward curve looks best. Braun's guidance is similar: end the line somewhere between the top and bottom of your Adam's apple.

Then shave off the hair below the line. The AAD suggests shaving in the direction your hair grows, since shaving against the grain can cause ingrown hairs.

Step 4: Cheek line, mustache and fade

Braun All-in-One Series 7 trimmer
Image: Braun

Cheek line: this is optional. Philips says if you're happy with a natural cheek line, leave it. For a crisper look, trim a straight or slightly rounded line from the bottom of your sideburns, holding the blade perpendicular to your skin. Philips notes that a lower cheek line makes your face look longer.

Mustache: Philips says you can trim it to the same length as your beard or leave it a little longer. For a clean lip line, brush the hair down and trim any hair growing over your top lip.

Fade: to blend your beard into your haircut, Philips suggests trimming about an inch above the jawline with the guard one setting shorter than the rest of the beard, then shortening the guard again for the next inch toward the sideburns. Keep going in one-inch steps until the sideburns blend into your hair.

Small adjustments at a time work best. A fade that goes too high is hard to undo.

Beard care between trims

Braun beard care routine table: washing, oiling, trimming and combing frequency
Image: Braun

A healthy beard is easier to trim and looks better between trims.

  • Wash it. The AAD recommends washing your face and beard every day with a gentle cleanser rather than soap. Braun says to rinse with warm water and pat dry rather than rubbing, to avoid breakage.
  • Moisturize. The AAD suggests beard conditioner for acne-prone skin, beard oil for normal or dry skin, and a gentle moisturizer for sensitive skin. Use it sparingly to avoid a greasy look. Braun says beard oil is especially helpful in the early stages of growth.
  • Trim regularly. Braun's guidance varies with style: every two or three days for stubble, and every few days to every few weeks for a longer beard.
  • Hands off. The AAD advises against constantly touching and stroking your beard.

If you get painful bumps under your beard that don't go away, the AAD says razor bumps can cause permanent scarring if left untreated, so see a board-certified dermatologist.

Frequently asked questions

Should I trim my beard wet or dry?

+

Dry. Philips says to wash and dry your beard and face before trimming.

Where should my beard neckline be?

+

Philips says to place a finger just above your Adam's apple and trim below that line. Braun says between the top and bottom of the Adam's apple.

Should I trim with or against the grain?

+

Philips and Braun say to trim the beard against the grain. The AAD says to shave the neck with the grain to avoid ingrown hairs.

How often should I trim my beard?

+

Braun suggests every two or three days for stubble and every few days to few weeks for longer beards.

Sources

RV
Rahul Vithala

Editor-in-Chief

Rahul has been writing about gadgets and software since 2013, first at Thetechhacker and now at Man Made Things. He edits every review on the site and signs off on every verdict.

More from Rahul →

Keep reading